Ultimate1MB Installation - XE series

[import gadget="Menu" action="Display" params="7"]

Nessesary fix

Since the Xilinx XC95144XL chips are not that 5V tolerant, and some cartridges tie 5V line directly to RD4 and RD5 inputs, some provisions have to be taken. If i knew about this (they failed to mention it in the datasheet) that fix would have been incorporated on the Ultimate1MB board, but I didn"t.This is a necessary step, and failing to accomplish it will lead to failure of the Ultimate 1Mb board.

Basically you need to cut 2 traces, and patch them back together using resistors from accessory kit.
Below, 130XE is shown.

Cut the trace leading from pin A of the cartridge connector (its marked on silkscreen of the motherboard) to pin 7 of the MMU. Use a DMM to verify that you"re cutting the correct trace.

Cut RD5 trace leading from pin 14 of cartridge connector, to pin 8 of MMU. Make sure you"re cutting the correct trace.

Now use provided resistor to reconnect RD4 and RD5 signals as shown. After this you may want to power up your Atari again. It should work as usual including all cartridges.

Connection points

The very last thing you need to do is, solder four wires from the DuPont connector you prepared above - these are PHI2, RW, RESET, and HALT signals that are not present on MMU or OS ROM chips and have to be taken from somewhere else to get the board operational.